Adjusting the SP/HP Mechanical Trigger

Adjusting the trigger of SPNew, SPNew RF, HPNew (Mechanical Trigger)

LL ADJUSTMENTS SHOULD BE DONE HOLDING THE PISTOL UPSIDE DOWN. NEVER TURN ANY SCREW MORE THAN ¼ TURN AT A TIME. USE CAUTION WHEN ADJUSTING THE TRIGGER.

SCREWS RG: Unscrew any of the three screws to adjust trigger position.

SCREW CS: Turn clockwise to lengthen the second stage traveland counter clockwise to shorten until it disappear (single stage trigger).

SCREW PS: Inside screw CS. Turn clockwise to increase second stage weight and vice versa.

SCREW PG: This regulates the disconnector engagement on the sear. Turn clockwise to reduce the freeplay before the first stage trigger.

SCREW PP: Give a wide range of adjustment in the first stage weight. Turning clock wise increases the weight to over 1360 grams and vice versa reduces the weight to less than 1000 grams.

SCREW TS: This function as an adjustable trigger stop. Turn clockwise to reduce over travel.

SCREW CP: Turn clockwise to reduce first stage travel. Turning clockwise will reduce the sear engagement. CAUTION: if this screw is adjusted too far clockwise the sear will not re-engage. Once the desired adjustment is achieved. ALWAYS re-adjust screw PG, to ensure that the disconnector is correctly adjusted on the sear.

CAUTION: If the screws TS and CP are adjusted too far clockwise, the trigger will not function.

 

Copyright © 2024