Adjusting the SP1/SP1RF Electronic Trigger

Adjusting the trigger of SP1/SP1 RF (Electronic Trigger)

ALL ADJUSTMENTS SHOULD BE DONE HOLDING THE PISTOL UPSIDE DOWN. NEVER TURN ANY SCREW MORE THAN ¼ TURN AT A TIME. USE CAUTION WHEN ADJUSTING THE TRIGGER.

SCREW RG: Unscrew to adjust trigger position.

SCREW CS: Turn clockwise to lengthen the second stage traveland counter clockwise to shorten until it disappear (single stage trigger).

SCREW PS: Inside screw CS. Turn clockwise to increase second stage weight and vice versa.

SCREW PP: Give a wide range of adjustment in the first stage weight. Turning clockwise increases it, while counterclockwise reduces it.

SCREW TS: This function as an adjustable trigger stop. Turn clockwise to reduce over travel.

SCREW CP: Turn clockwise to reduce first stage travel.

CAUTION
: If the screws TS and CP are adjusted too far clockwise, the trigger will not function.

To adjust the trigger, you should hold the pistol upside down. Pardini offers a convenient side opening on the frame, where you can see the lever and the screws – where they go and what they do. Remember to turn each screw no more than ¼ turn at a time. Prepare to spend some time on it, don’t start it if in rush, but it’s worth it, you will have a personalized trigger. Pardini trigger offers fine, all dimensions adjustment – you can have the trigger you wish, while you can see what you are doing through the side openings.

Are you 18 or older?

Copyright © 2024